文化大學機構典藏 CCUR:Item 987654321/26579
English  |  正體中文  |  简体中文  |  全文筆數/總筆數 : 46867/50733 (92%)
造訪人次 : 11891150      線上人數 : 699
RC Version 6.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜尋範圍 查詢小技巧:
  • 您可在西文檢索詞彙前後加上"雙引號",以獲取較精準的檢索結果
  • 若欲以作者姓名搜尋,建議至進階搜尋限定作者欄位,可獲得較完整資料
  • 進階搜尋
    主頁登入上傳說明關於CCUR管理 到手機版


    請使用永久網址來引用或連結此文件: https://irlib.pccu.edu.tw/handle/987654321/26579


    題名: 利用LabVIEW軟體模擬風機與PID控制器之全系統性能研析
    Performance Simulation of the Wind Turbine System with DFIG and PID Controller Using LabVIEW
    作者: 黃正庭
    Thien, Huynh Thanh
    貢獻者: 機械工程學系數位機電碩士班
    關鍵詞: Wind turbine
    doubly fed induction generator
    PID controller
    LabVIEW
    human machine interface
    日期: 2014
    上傳時間: 2014-01-23 14:52:26 (UTC+8)
    摘要: Nowadays, the consumption of the electrical energy on the world rises considerably. Wind energy has become one of an acceptable alternative energy in many generate electrical ways because it is safe and clean renewable - energy source and have economic benefits.
    In this thesis, the modeling of wind turbine systems (WTS) applying DFIG is proposed. The mathematical of WTS is analyzed theoretically and simulation is performed in LabVIEW platform. Besides, controllers are also applied into this system. The Proportional – Integral – Derivative (PID) algorithm is the most common control algorithm used in industry, especially in servo motor control. PID controllers are often used when these controllers are needed to close the loop and sometimes the complex plane has not enough stable in margin, or the performance is less than requirements. In this study, PID controller is applied into WTS to control the pitch angle. All of characteristic parameters, the power generation process and control responses can be observed easily on LabVIEW through human machine interface (HMI). This HMI not only shows the extensive look of the whole system but also allow the user to import or editing necessary parameters for calculation, monitor and control of system.
    Additionally, a comparison of the output responses of P, PI and PID controllers is implemented by LabVIEW and Matlab and comparison in performance of LabVIEW and Matlab environments is also implemented in this study. From the simulation results of the system with the controllers indicated that PID controller has not only faster rising time, settling time response but also small steady-state error, overshoot is lower than the conventional P and PI controllers. Computing time in LabVIEW environment is less than Matlab with value which calculated in this study.
    顯示於類別:[機械工程系暨機械工程學系數位機電研究所] 博碩士論文

    文件中的檔案:

    沒有與此文件相關的檔案.



    在CCUR中所有的資料項目都受到原著作權保護.


    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 回饋